Category Archives: CLI

CLI

Creating a ZFS RaidZ volume with different sized disks

Leave a comment

While I hear that “ZFS likes to use the whole disk” I wanted to experiment with creating a RaidZ pool with disks of different sizes. This requires partitioning the larger disks. The GUI in FreeNAS does not allow you to do this, so we must venture toward the command line. While these commands were run in FreeNAS they will work in any FreeBSD based system.

The commands below assume you are using the first four disks in the system for the RaidZ pool. I realize you can make these commands more efficient by using shell-fu but I will put them all here for completeness.

Partition the disks

Create GPT table for each disk

  • gpart create -s gpt ada1
  • gpart create -s gpt ada2
  • gpart create -s gpt ada3
  • gpart create -s gpt ada4

If gpart complains (probably due to the disk already having a GPT table) you can nuke the GPT setup and start over via the following commands, replacing ada2 with the stubborn drive:

  •  gpart destroy -F ada2
  • gpart create -s gpt ada2

Create partition for each disk

  • gpart add -s 232G -t freebsd-zfs -l test0 ada1
  • gpart add -s 232G -t freebsd-zfs -l test0 ada2
  • gpart add -s 232G -t freebsd-zfs -l test0 ada3
  • gpart add -s 232G -t freebsd-zfs -l test0 ada4

Create the pool

  • zpool create storage raidz ada1p1 ada2p1 ada3p1 ada4p1

Why does everyone call their pool “tank”? It must be in some documentation somewhere that everyone copies.

If you want to replace a failed disk in a pool after the faulty disk has been removed, issue the following command:

  • zpool replace storage <old/failed device name> ada2p1

Sometimes even though you’ve nuked the gpt data of the disk zpool will complain about the disk already being a member of a pool, e.g. “/dev/ada2p1 is part of active pool ‘storage'” Another scenario is if you have properly replaced the failed drive but the pool still shows degraded with a hash referring to the old drive showing in zpool status. To fix these issues use the zpool detach command

zpool detach storage ada2p1

 Check pool status

  • zpool status

If it comes out healthy you are good to go.

Import the raidZ into FreeNAS

With the pool manually created you can now import it into FreeNAS so it can be monitored / managed.

  • Click on Storage / Volumes / Auto Import Volume
  • Click No, skip to import
  • Wait a minute for it to scan, then click OK

Done.