Tag Archives: ipmitool

Supermicro fans constantly spinning to 100% fix

My fancy new Supermicro-powered AMD Epyc 7 series server is the bee’s knees. When I first set up I had an annoying problem though – the fans would spin to 100% and back down to normal speeds constantly. Logs kept spamming the same thing over and over:

SENSOR_NUMBER: 45
SENSOR_TYPE: Fan
SENSOR_NAME: FAN5            
EVENT_DESCRIPTION: Lower Critical going low
EVENT_DIRECTION: Assertion
EVENT SEVERITY:"information"
SENSOR_NUMBER: 45
SENSOR_TYPE: Fan
SENSOR_NAME: FAN5            
EVENT_DESCRIPTION: Lower Critical going low
EVENT_DIRECTION: De-assertion
EVENT SEVERITY:"information"

It was doing this for all 3 fans I had plugged in there. I finally came across this post which explained what the problem was. The fans I had installed defaulted to a low RPM mode, too low for the motherboard’s liking. The BMC would detect the low RPM and assume something was wrong and bring all fans to 100% in order to rescue the system. After doing this it would see the RPM go back to normal range and turn off the “emergency fan mode” only to turn back on when the RPMs of my fans went below the threshold.

The fix, thankfully, is pretty simple provided you have ipmitools installed. One simply has to use the tool to change the fan thresholds. For my Debian-based Proxmox install I did the following to quiet this beast:

apt install ipmitool
ipmitool sensor thresh FAN1 lower 300 300 400
ipmitool sensor thresh FAN2 lower 300 300 400
ipmitool sensor thresh FAN5 lower 300 300 400
#you'll want to modify the fans to correspond with your own server.

I ran the above commands to turn my 3 fans back to a sane speed. I got caught up for a while because I only ran this command on 2 of my 3 fans at first. The deafening noise continued. This is because if any fan in the system goes below, all fans spin up. Once I changed that third fan’s threshold all was gravy. My ears were ringing for a while, but they’re fine now.